連接箱盤面板上的電器及控制臺等可動部位的電線應采用多股銅芯線并留有余量，線束外套塑料管加強絕緣，成束綁扎，不同電壓等級，不同控制回路應分別綁扎，標識明確，與電器連接時，端部鉸接，設備安裝應保證牢固、端正，移動式設備應裝設在堅固的支架上，固定式設備的下底面與地面的垂直距離應大于1。3m，小于1。5m；所有的配電箱必須具備良好的防雨防塵措施。配電箱的焊接、螺栓連接均應牢固，焊縫應均勻、光潔、無焊皮、焊穿、氣孔等不良現象;螺栓的連接應有平、彈簧墊圈、外露絲扣2—5扣。配電箱內部零件、開孔邊緣應平整光滑。

配電箱箱體選用的鋼板厚度不小于1。5mm，配電箱箱體厚度不小于2。0mm厚度的冷軋鋼板制成，鋼板箱門、鋼板盤面厚度不小于2。0mm。背板的厚度不小于3。0mm。照明配電箱采用不當，增加了照明配電箱的故障率，選用低阻產品(如低阻熔斷器)，不僅能降低損耗，而且還能減少配電箱內集聚的熱量，延長設備的使用壽命。每臺用電設備應有各自的的開關箱。施工現場每臺用電設備應有各自的開關箱，且必須滿足“一機一閘一漏”要求，工地正規二級配電箱，嚴禁用同一個開關電器直接控制兩臺及兩臺以上用電設備(包含插座)。

照明配電箱分金屬外殼和塑料外殼兩種，有明裝式和暗裝式兩類，其箱體必須完好無缺。照明配電箱配電箱不宜安裝過高，一般安裝標高為1。8米，以便操作;進配電箱的電管必須用鎖緊螺帽固定。連接線要使用絕緣導線，不得有漏電部分。工作零線要通過接線端子板連接，與保護零線接線端子板分設；金屬箱體、電器安裝板以及電器的不應帶電金屬底座，外殼必須有接零措施。為了方便使用和延長配電箱使用壽命，應該將其安置在干燥度高、便于通風、采光良好的地方，只要不影響美觀和妨礙使用即可。配電箱盡量靠近用電量大、用電設備多以及進出線方便的地方。