對施工人員及施工程序的要求 ;屋面工程的防水必須由防水隊伍或防水工施工，昌都滲透結晶防水涂料，嚴禁沒有資質書的單位和非防水隊伍或非防水工進行屋面工程的防水施工，建設單位或監理公司應認真地檢查施工人員的上崗證。施工中施工單位應按施工工序、層次進行質量的自檢、自查、自糾并且做好施工記錄，監理單位做好每步工序的驗收工作，驗收合格后方可進行下道工序、層次的作業。3.對pvc防水卷材的質量要求 ;屋面工程所采用的防水材料應有材料質量證明文件，并經質量檢測部門認證，滲透結晶防水涂料多少錢，確保其質量符合《屋面工程技術規范》（GB50207 94）或國家有關標準的要求。

而SBS卷材的熱熔施工易對環境造成污染，滲透結晶防水涂料批發，因施工不當造成火災的情況也時有發生。冬季防水要特別注意防水材料的選擇以及施工注意要點要謹記，不要冬防夏漏，這是讓人犯愁的情況，因為我們花錢花時間做的防水換來的卻是一次次的滲漏!高分子自粘防水卷材自粘防水卷材施工注意事項。(1)、 防水基面(找平層)必須堅硬、平整、干燥(含水率不宜大于10%)清潔、不應有反砂及各種尖利物品。(2)、作業基面上如有積雪、積水冰霜時不得施工。(3)、自粘防水卷材不宜在負溫條件下施工，如必須在負溫下施工時，應采取措施保證鋪好后的防水層不得有龜裂及粘結不良現象。

立面和大坡面的鋪貼：由于自粘型卷材與基層的粘結力相對較低，在立面或大坡面上，卷材容易產生下滑現象，因此在立面或大坡面上粘貼施工時，宜用手持式噴燈將卷材底面的膠粘劑適當加熱后再進行粘貼、排氣或輥壓。??（5）大面積卷材排氣、壓實后，再用手持小壓輥對搭接部位進行碾壓，從搭接內邊緣向外進行滾壓，排出空氣，粘貼牢固。??（6）接縫粘貼與密封：??