新增負載時，需考慮新增電流是否超出控制該回路空氣斷路器的額定電流。超出時需更換成相應容量的空氣斷路器。更換空氣斷路器前要斷電，更換后要固定牢固。配電箱、開關箱內的電器（含插座）應先安裝在金屬或非木質阻燃絕緣電器安裝板上，然后方可整體緊固在配電箱、開關箱箱體內。金屬電器安裝板與金屬箱體應做電氣連接。高壓配電室應為一、二級耐火等級建筑。低壓配電室的耐火等級不應低于三級。配電室的窗應有防水、防雨雪、防小動物進入的措施。高、低壓配電裝置同在一室時，它們之間的距離應不小于1米。

配電箱內電器選擇不當引起的故障：由于在制造時對交流接觸器容量選擇不很恰當，對不同出線回路安裝同容量的交流接觸器，且未考慮到三相負荷的不平衡情況，總配電箱電器額(e)定值、動作整定值，應與分路開關電器的額(e)定值、動作整定值相適應。并裝設總自動開關、漏電保護器和分路自動開關。各級配電箱中使用的各種電氣元件和漏電保護器應符合質量要求。連接線要使用絕緣導線，不得有漏電部分。工作零線要通過接線端子板連接，配電箱價格，與保護零線接線端子板分設；金屬箱體、電器安裝板以及電器的不應帶電金屬底座，外殼必須有接零措施。

照明配電箱的箱下底與地面的垂直距離宜大于1。3m，小于1。5m。移動式分配電箱、開關箱的下底與地面的垂直距離宜大于0。6m，小于1。5m，并且移動式電箱應安裝在固定的金屬支架上。配電箱的外涂層顏色應根據甲方的要求進行靜電噴塑，涂層應附著牢固，顏色均勻，無皺i紋、剝落、斑點、漏噴等不良現象，在距離1米處觀察無明顯色差和反光，表面平整、干凈，無凹坑、劃痕等損傷現象。為了方便使用和延長配電箱使用壽命，應該將其安置在干燥度高、便于通風、采光良好的地方，只要不影響美觀和妨礙使用即可。配電箱盡量靠近用電量大、用電設備多以及進出線方便的地方。