配電箱、開關箱內的電器（含插座）應先安裝在金屬或非木質阻燃絕緣電器安裝板上，然后方可整體緊固在配電箱、開關箱箱體內。金屬電器安裝板與金屬箱體應做電氣連接。設備安裝應保證牢固、端正，移動式設備應裝設在堅固的支架上，固定式設備的下底面與地面的垂直距離應大于1。3m，小于1。5m；所有的配電箱必須具備良好的防雨防塵措施。配電箱蓋應完好無損，操作完畢后及時將蓋子蓋上。在更換空氣斷路器時，要綜合考慮配電箱的額定電流、負載的額定電流等，且更換的空氣斷路器仍要以向上操作為合閘的原則安裝。

電器元件要求：配電箱、開關箱內電器元件必須可靠、完好，嚴禁使用破損、不合格電器。電器產品進場時必須審驗生產（制造）許可證、產品合格證、產品說明書、出廠檢驗記錄。照明配電箱分金屬外殼和塑料外殼兩種，有明裝式和暗裝式兩類，其箱體必須完好無缺。照明配電箱配電箱不宜安裝過高，一般安裝標高為1。8米，以便操作;進配電箱的電管必須用鎖緊螺帽固定。連接箱盤面板上的電器及控制臺等可動部位的電線應采用多股銅芯線并留有余量，線束外套塑料管加強絕緣，配電箱哪家好，成束綁扎，不同電壓等級，不同控制回路應分別綁扎，標識明確，與電器連接時，端部鉸接，。

照明配電箱的箱下底與地面的垂直距離宜大于1。3m，小于1。5m。移動式分配電箱、開關箱的下底與地面的垂直距離宜大于0。6m，小于1。5m，并且移動式電箱應安裝在固定的金屬支架上。配電箱的外涂層顏色應根據甲方的要求進行靜電噴塑，涂層應附著牢固，顏色均勻，無皺i紋、剝落、斑點、漏噴等不良現象，在距離1米處觀察無明顯色差和反光，表面平整、干凈，無凹坑、劃痕等損傷現象。為了方便使用和延長配電箱使用壽命，應該將其安置在干燥度高、便于通風、采光良好的地方，只要不影響美觀和妨礙使用即可。配電箱盡量靠近用電量大、用電設備多以及進出線方便的地方。