鋰電池戶外存儲柜擁有歐洲頒發的防爆認證防滲漏托盤系統；較強的防液體泄漏功能防銹鍍鋅鋼板，鋼焊接主體適用于暫存各類鋰電池可配備多種系統：艙外滅火系統、安全防護系統、消防安全系統、門禁系統及廢氣凈化系統；艙內自動消防滅火系統、噴淋降溫系統、溫濕度控制系統、漏液回收系統、照明系統 、排氣通風系統、自動報警系統及防爆供電系統；防雷系統、靜電處理系統.

電氣控制部分

(1)延遲系統：通氣自動控制系統作用是可以有效的確保正壓防爆柜使用時進行通氣，在通氣進行后才能進行下一步實際操作，不銹鋼氣瓶柜，這一過程被稱作延遲系統，與此同時這也是確保防爆性能強制流程。

(2)壓力監控系統：對正壓力機殼壓力必須做到實時檢測，運用液位傳感器對工作壓力信息進行剖析解決，更能體現壓力值并把它傳送至DCS集散控制系統的分控中心。

(3)報警設備：運用自動持續監控系統及壓力監控系統對輸出后控制信號展開分析解決，從而形成執行系統，主要包括正壓力機殼里的正壓力值小于50Pa或是超機殼髙壓強制自動斷電或警報及展示作用等。

(4)自動持續監控系統：運用DCS集散控制系統將壓力撿取、監管、通氣、警報、監管及壓力出現異常等狀況進行監管、動作、監控及分散中控。

對于以上防爆控制柜工作原理和結構特征，正壓防爆柜的安全防范措施必須符合如下所示這幾個方面：

(1)選用互鎖便于使門和蓋打開后，防爆型式的保護電氣設備供電系統的開關電源可自動斷開，并且在門和蓋合閉之前不可以再次通電，或是門和蓋可以用工具或鎖匙打開并具有警示標志“通電時無法打開”。

(2)對顯示屏和壓力傳感器進行檢驗，關鍵方式就是警報或是自動斷電，可以有效的確保正壓力機殼內低、較大工作壓力不得超過標準值。

(3)確保通氣時長可以達到生產廠所規定時間設備及低通氣總流量。在其中保險裝置包含定時器、壓力、空氣流量計等。

(4)將阻火閥、火花及顆粒物隔板安裝在正壓力機殼出氣口，規避炙熱顆粒物吹進風險公共場合。