金力特為您介紹YBF3風機用電機的故障現象和原因分析：

故障現象：電動機起動時保險絲熔斷。原因：①定子線圈一相反接。②定子線圈短路或接地。③軸承損壞。④傳動皮帶太緊。⑤被帶動機械卡住。⑥起動時誤操作。

故障現象：電動機起動后轉速較低。原因：①電源電壓過低。②將三角形接線的電動機接成星形。③定子線圈短路。④轉子的短路環、籠條斷裂或開焊。⑤電動機過負荷。

風機防爆電機啟動時應注意以下事項：

1、合閘起動前，應觀看電動機及機械上或附近是否有異物，以免發生人身及設備事故。

2、防爆電機接通電源后，如果發現電動機不能起動或起動時轉速很低以及聲音不正常等現象，應立即切斷電源，對高壓異步防爆振動電機應進行試起動，YBF3風機用電機生產廠家，察看其轉動方向是否正確。

3、起動多臺防爆電機時，應按容量從大到小一臺一臺起動，YBF3風機用電機生產商，不能同時起動，以免起動電流過大使斷路器跳閘。

4、對于籠型防爆電機的星形——三角形起動或自耦減壓起動，若是手動延1時控制的起動設備，應注意起動操作順序和控制好延1時長短。對于繞線型電動機的起動。更應注意起動操作程序和觀察起動過程是否正常。否則兩種電動機都達不到降1壓起動的目的。

5、防爆電機應避免頻繁起動或盡量減少起動次數，防止因起動頻繁而使防爆振動電機發熱，影響電動機的使用壽命。對于小型電動機，在冷態時不得超過3~5次，在長期工作后的熱態下，停機不久再起動時，連續起動不得超過2～3次。對于中型防爆電機，在冷態時連續起動不應超過兩次，熱態下只允許1次起動，以免電動機過熱，影響使用壽命。對起動時間不超過2~3秒的電動機，可多起動一次。

6、多臺起動機應避免同時起動，應從容量大的到小的逐臺起動，以免線路上總的起動電流過大，電壓下降太多，影響所有防爆電機的正常起動，YBF3風機用電機報價，甚至使開關設備跳閘。

軸流防爆電機配件為何要進行浸漆：

1、防爆電機的調速馬達要浸漆是提高繞組的電氣性能和機械強度。

2、提高繞組絕緣的喝血穩定性，使其具有防霉、防電暈、防油污等能力。

3、提高繞組絕緣的耐潮性能。

4、減緩繞組絕緣的老化速度，湖北YBF3風機用電機，提高導熱性能，增加散熱效果。

德州金力特電機公司研發和制造中小型電機，主要生產YE2、YE3高1效節能三相異步電動機、YB3、YBF3隔爆型三項異步電機、YD、YDT、變相多速三相 異步電動機、YSF、YT風機三相異步電動機、YVF2系列變頻調速三項異步電機，歡迎來電洽談業務合作！